Duplex stainless steel small buffer for gas boiler

Duplex stainless steel 2205 surge tanks will never corrode and weigh half as much as steel surge tanks. These benefits can reduce labor costs for installation while being a cost-effective way to increase system efficiency by reducing heat pump short cycling during low load periods and hydraulically decoupling the source from the distribution system. Our NSF certified polypropylene core is rated to 180 degrees Fahrenheit at 75 PSI and 140 degrees Fahrenheit at 100 PSI, surrounded by a continuous fiberglass and high temperature resin blend, making SST surge tanks ideal for hydronic and geothermal heating and cooling, low mass boiler systems, and chilled water applications. Argosy tanks are insulated with closed cell foam to provide R-values ​​unmatched by competitors with heat losses of less than 1 degree/hour. Tanks are available in 30, 50, 80, 120, 150, 200 liter sizes and all feature 4 side ports, a hot well, vent, vacuum breaker, and drain.

Operation: The primary purpose of a buffer tank is to reduce short cycling of a heat pump, chiller or boiler. A hydraulic buffer tank is used in systems that experience below design load conditions most of the time, or in systems that call for multiple low BTU cooling or heating loads at different times. This can cause the heat pump or boiler to short cycle, which reduces operating efficiency and shortens the life of the equipment.

What It does: The buffer tank has 4 connections built into it. Two connections can be piped to the heat pump or boiler and two connections can be piped to the distribution system. If piped correctly, the tank can act as a thermal buffer and a hydraulic decoupler. The heat pump or boiler can be hydraulically decoupled from the distribution system.